How to Measure Wiper Blades

By Nan Liang · Updated 2026-11-20

Measure the blade itself, end to end, in inches — never the arm. Replacement blades are sold in whole-inch lengths from 10″ to 28″, and on most cars the driver side is longer than the passenger side (a 26″/18″ pair is the most common combination in the US). If the blade is worn past reading, measure the arm's wipe pattern instead: mark where the blade stops at each end and measure between the marks.

The 30-second method

  1. Lift and lookPull the arm off the glass. Many blades have the size molded into the rubber or printed on the frame (e.g. "24"). If you can read it, you're done.
  2. Measure blade end to endHook a tape measure on one end of the blade (the metal or plastic end, not the rubber tip) and run it to the other end. Round to the nearest whole inch — blades only come in whole inches.
  3. Measure each position separatelyDriver, passenger and rear are three independent sizes. Never copy the driver size to the other side.
  4. No size printed and no tape?Use a ruler against the arm: the blade length is the arm length minus about 1–2 inches. Then confirm against a year-by-year chart like our vehicle size chart before ordering.

The three mistakes that cause returns

Rounding: when the measurement falls between sizes

If you measure 25.5″, buy 26″. Blades are sold in whole inches, and a blade ½ inch long wipes a little more glass — harmless. A blade half an inch short leaves an unwiped stripe in your line of sight, which is why you always round up, never down.

Related

Wiper sizes A–Z →

Find your vehicle's blade sizes

Wiper arm types →

Identify your connector

How to measure blades →

Verify before you buy